Select your language

  • Français (France)
  • English (United Kingdom)
  • Español
  • Italiano
  • Deutsch

Before the launch in handling I/O GPIO of Raspberry, it is preferable to design a small circuit board that will prevent your lovely raspberry makes the soul in mishandling.

That is why it is important to protect the GPIO.

For information, you have a total of 17 GPIO on the Raspberry PI.



The finished GPIO protection board: IDC connector in the middle, resistors, Zener diodes and labelled terminal blocks


GPIO


Pinout of the Raspberry Pi P1 GPIO header (26 pins): 3.3 V and 5 V power, ground and numbered GPIOs

Source : Wiki Raspberry PI


Principle of protection of GPIOs

To prevent entry of Raspberry Pi being subjected to a voltage higher than the recommended max 3.3V
We will make this little montage of each GPIO Raspberry Pi


Protection circuit for one GPIO: a 330 Ω resistor in series to “GPIO BIS” and a 3.3 V Zener diode to ground


materials needed

Here is the list of materials needed :



IDC connectors


The purpose of this manipulation is to have a tablecloth that easily connect to the GPIO of Raspberry PI.
This sheet will serve as a liaison between GPIO and card protection.

As a first step: cut the length you need.
20 cm seems to me a reasonable length.



A rainbow ribbon cable and three IDC connectors to crimp

Then you should crimp IDC connectors on the cable.
Insert on the tablecloth then tightened correctly, for that I suggest you a vise or clamp.


Close-up of an IDC connector crimped onto the ribbon cable

And final result (with a nice faux-fitting ^^)

The finished ribbon cable with its IDC connectors


Card design

Mounting :

Assembly layout on the stripboard: solder points in green, cut copper strips in red

And here is the card once welded correctly.

The protection board once the components are soldered

Of course, depending on the type of test that you purchase you will have to adapt it to match your expectations card.
And for some cards (copper bands), armed with a knife, you cut some tracks.


The underside of the stripboard: the component solder joints, in three areas framed in red


About

Creator of innovative solutions
Android | iOS | Web | NFC

Keep in touch

Reddit Instagram YouTube Bluesky X (Twitter) Facebook Threads LinkedIn Mastodon Newsletter